Restarting a L208 Wireless Sensor

  1. Power off the sensor: Slide the switch to the OFF position, towards the dot, to power off the sensor. The dot indicates the OFF position.
  2. Wait 30 seconds.
  3. Power on the sensor: Slide the switch to the ON position, away from the dot, to power on the sensor. The LED indicator should flash red, confirming that the sensor is powered.
     
  4. Check the System Health page: Confirm the sensor is showing as online after it has fully rebooted. If the sensor shows as offline, repeat steps 1-3.

If the sensor is still offline after performing the steps above, please contact VergeSense support (support@vergesense.com) for additional assistance.

Updated

Was this article helpful?

0 out of 0 found this helpful

Comments

0 comments

Please sign in to leave a comment.