Restarting Your Wired (E105/E106) Sensor

If you need to restart your wired sensors (E105/E106 models), follow the instructions below:

  1. Unplug the ethernet cable from RJ45 port.
  2. Wait 30 seconds.
  3. Plug in the ethernet cable back into RJ45 port.
  4. A rapid or slow blinking red light will indicate the device is powered back on. If the light does not appear, repeat steps 1-3.

Screen_Shot_2023-01-25_at_3.56.42_PM.png

Updated

Was this article helpful?

0 out of 0 found this helpful

Comments

0 comments

Please sign in to leave a comment.