Regulatory and Safety Information: Wired (E105/E106) Sensors

GENERAL SAFETY INFORMATION
  • Do not immerse in water and do not spill or pour liquids of any kind onto or into any parts of it.

  • Use an antistatic cloth. Please avoid water and liquid or solid cleaning products as they might damage the surface or internal electronics.

  • Intended for indoor installation only, unless explicitly specified otherwise.

  • Device and accessories may contain small parts. Keep them out of the reach of small children.

  • Read the mounting instructions carefully before beginning installation. Failure to use the correct hardware or to follow the correct procedures could result in a hazardous situation to people and damage to the system.

  • Use only attachments/accessories provided by VergeSense or explicitly recommended by VergeSense.

  • Unauthorized opening, changing, or modifying the device will cause the warranty to lapse and may also result in the loss of CE / CFF conformity. In case of malfunction contact authorized service personnel.

WIRING GUIDELINES

These guidelines apply for any cable, supplied or not, used with a VS-E105 sensor

  • Cables must not pull or create lateral stress on the connectors, i.e. they must be long enough.

  • Cables must be installed in such a way as not to present a trip hazard to personnel working in the vicinity of the equipment.

  • Keep cables away from:

  • Sources of electrical noise such as radios, transmitters, and broadband amplifiers

  • Power lines

  • Fluorescent lighting fixtures

  • Liquids or moisture

  • Heat sources

  • Always use standard telecommunication cables with a minimum of 26 AWG wire gauge.

INSTALLATION WARNINGS

  • Compliance is required with respect to voltage, and current requirements indicated on the manufacturer’s label. Connection to a different power source than those specified may result in improper operation, damage to the equipment or pose a fire hazard if the limitations are not followed.

  • When PoE is used as power source, it should be connected to a power-over-ethernet (PoE) IEEE 802.3af compliant power source or an IEC60950 compliant limited power source.

  • To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits to telephone-network voltage (TNV) circuits. LAN ports contain SELV circuits, and WAN ports contain TNV circuits. Some LAN and WAN ports both use RJ-45 connectors. Use caution when connecting cables.

  • Voltages that present a shock hazard may exist on Power over Ethernet (PoE) circuits if interconnections are made using uninsulated exposed metal contacts, conductors, or terminals.

  • Installation of the equipment must comply with local and national electrical codes.

FCC NOTICE:

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1) This device may not cause harmful interference, and 2) This device must accept any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.

  • Increase the separation between equipment and receiver.

  • Consult the dealer or an experienced radio/TV technician for help.

NOTE: Changes or modifications to this unit not expressly approved by VergeSense could void the user’s authority to operate the equipment.

Model: VS-E105

FCC part 15.247 modular certification FCC ID: 2AC7Z-ESP32WROVERB

CANADA

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

Canada (ISED) modular certification: 21098-ESPWROVERB

CAUTION - ELECTRIC PRODUCT.

Not recommended for children under 3 years of age. As with all electrical products, precautions should be observed during the handling and use to prevent electrical shock. FOR INDOOR, DRY-LOCATION USE ONLY.

The transformer is not a product and should be connected to the wall outlet by an adult. It should be periodically examined for conditions that may result in the risk of fire, electrical shock or injury to persons, such as damage to the cord, plug, blades, housing or other parts, and in the event of such conditions, the transformer must not be used until the damage is repaired.

  • The product must be used only with the recommended transformer.

  • The product is not to be connected to more than the recommended number of power supplies.

  • Products to be cleaned with a liquid are to be disconnected from the transformer before cleaning.

  • To clean transformer, disconnect it from the wall and clean with a cloth dampened with water. Do not immerse in water or use soap or other chemicals. Allow to dry before reusing. Do not connect to the AC outlet if wet or damaged.

Electrical Ratings:

Option #1: PoE Power

  • Input AC Power: 36-57V (IEEE 802.3af) via Ethernet Connector (RJ-45)

  • Power Consumption ~3.2W

Option #2 DC Power

  • Input: 12V DC Input

  • Power Consumption ~3.2W (Active)

EUROPE:

VergeSense declares that VS-E105 comply with the essential requirements and other relevant provisions of Radio Equipment Directive 2014/53/EU. A copy of the Declaration of Conformity is available on request. VergeSense, 4 Embarcadero, Suite 1500, San Francisco, CA, 94111

Environmental Phenomena

The unit may malfunction if subjected to radio-frequency interference. It should revert to normal operation when the interference stops. If not, it may become necessary to turn the power off and back on, or remove and reinstall the batteries. In the unlikely event of an electrostatic discharge, the unit may malfunction and lose memory, requiring the user to reset the device by removing and reinstalling the batteries.

Recycle Information

For information on how this product might be recycled, email to support@vergesense.com

Customer Service Contact

For customer service, email to support@vergesense.com

Limited Warranty

Product is subject to a limited 36-month warranty. Email our customer service at support@vergesense.com with details of the warranty provided in your country. VergeSense shall not be liable for any incidental or consequential damages for the breach or any warranty on this product. Some jurisdictions do not allow the exclusion or limitation of incidental or consequential damages, or limitation on how long an implied warranty lasts, so the above limitations or exclusions may not apply to you.

Authorized Territories

The VS-E105 is authorized for use in the following countries:

Australia, Austria, Bangladesh, Belgium, Bulgaria, Canada, Comoros, Croatia, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Japan, Georgia, Germany, Greece, Guadeloupe, Hong Kong, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Martinique, Myanmar, Netherlands, New Zealand, Norway, India, Poland, Portugal, Romania, Saint Barthelemy, Saint Martin, Singapore, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turks and Caicos, United Kingdom, UAE USA.

Environmental Compliance:

RoHS Compliance

This product is in compliance with Directive 2011/65/EU of the European Parliament and of the Council of 8 June 2011, on the restriction of the use of certain hazardous substances in electrical and electronic equipment (RoHS) and its amendments.

REACH

REACH (Registration, Evaluation, Authorization and Restriction of Chemicals, EC No 1907/2006) is the EU chemical substances regulatory framework. VergeSense complies with all requirements of the regulation and we are committed to providing our customers with information about the presence of REACH Substances of Very High Concern (SVHCs).

Updated

Was this article helpful?

0 out of 0 found this helpful

Comments

0 comments

Please sign in to leave a comment.