Footprint

Figure 1: Surface mounting footprint

Mounting instructions

Pull the Ethernet cable through the hole in the ceiling and plug in the sensor.

Figure 2: Connect the Ethernet cable through the hole

Fit the EN-1 sensor onto the ceiling and use the two screws to fix the sensor. Please define the appropriate screw type depending on the ceiling consistency. The fixture must be able to carry the four-fold weight of the device, which would correspond to 20N for the EN-1.

Figure 3: Fix the EN-1 with 2 screws

Remove the dust caps from the sensor lenses (blue). And click the cover on the sensor.

Figure 4: Sensor shown with dust cap

Figure 5: Fully installed EN-1 device

Updated May 15, 2023 16:49