Restarting/Power Cycling Your (L302) Gateway

  1. Locate your gateway: The gateway may be white or black, depending on its network connection type (Ethernet, WiFi, or Cellular). Typically, white gateways are connected via Ethernet, while black gateways are connected via WiFi or Cellular. However, this may vary.

    PSC-SGW-101-DC Gateway by ATG LED Lighting in Souther CaliforniaRigado Presto: What's in the box | Rigado

  2. Identify the power source: It could be an Ethernet cable used for data and Power over Ethernet (PoE), or a standard power plug.

  3. Disconnect the power source: Unplug the Ethernet cable or the standard power plug from the gateway.

  4. Wait for a few seconds: Allow the gateway to completely power down by waiting 10-15 seconds before reconnecting the power source.

  5. Reconnect the power source.

  6. Observe the startup process: As the gateway powers on, there should be a solid yellow LED indicating that the gateway is booting.

  7. Once the gateway has fully booted, a solid green LED will indicate that the gateway has a healthy connection.

Updated

Was this article helpful?

1 out of 1 found this helpful

Comments

0 comments

Please sign in to leave a comment.